PLAMCOR®-6

Technical Data

Consumption

Theoretical spreading rate per coat of dry film thickness 1000 μ - 0,7 kg/m2

Surface Preparation

The surface must be primed beforehand.

The primer coating shall be cleaned from dirt, dust, degreased, dry, undamaged, not have any corrosive degradation. All damaged areas should be resurfaced.

Application

Preparation for use:

• stir thoroughly until homogeneous using power agitator (base and hardener separately);

• while stirring add the hardener (mixing ratio 3.6:1 by weight and 3.9:1 by volume);

Rinse the hardener remaining on the walls of the container by adding SOLV-UR thinner and pour into the base, then mix the components to a homogeneous consistency.

The working pot life of the composition after mixing is 1 hour (at a temperature (20±2)°C), if the temperature is higher the working pot life reduces.

• add thinner to reach working consistency directly prior to application.

Application conditions: at temperatures from minus 5 to plus 30 °C and relative air humidity not exceeding 80 %.

The composition shall be applied by airless spraying or trowel in 1-5 layers depending on the required thickness.

At low temperatures, the time of interlayer drying of the coating layers should be increased.

The time of drying for service of the PLAMCOR-6 coating at a temperature of (20±2)°С is at least 7 days (it depends on temperature, with its increase the time is reduced).

Service life of the coating

Fire-protective coating PLAMKOR-6 as part of a complex coating with fire-protective intumescent compounds of the PLAMKOR series, with a primer and topcoat enamel has a service life of at least 20 years when used in an open atmosphere of moderately cold and cold climates according to GOST 15150.

The coating maintains its fire protection efficiency for the specified period in the absence of mechanical damage and constant moisture condensation. After the specified period, the fire protection coating is subject to replacement with complete removal of the existing layer and its subsequent restoration.

Packing and Storage

The unit of PLAMCOR-6 is supplied as The Base in 20 litre metal containers and Curing Agent in 3 litre metal containers.

The product must be stored in accordance with GOST 9980.5 at ambient air temperature from minus 40 to plus 40 °C, away from sources of heat. During the storage, container with the material shall not undergo influence of atmospheric precipitation and direct sun beams.

Shelf life of the composition in tightly closed manufacture’s containers is 12 months from the production date.

The information is of general character, without consideration to the object specific nature and it is recommended to be read with the Operating Procedure. Use of materials for other purposes not specified here or in case other influencing factors are present shall be approved by the VMP Holding CJSC in writing. In case of absence of such approval the manufacturer is not held liable for the improper use of the material and the buyer falls from the right to present claims connected with the coating quality.