PLAMCOR®-1

Vinyl acetate water-dispersed paint with gas-and-foam-forming fillers, agents and pigments. The fire retarding properties of the coating PLAMCOR-1 are supported by the fire test results and Fire Safety Certificates issued by the accredited certification authorities and test centers according to the established legal procedure.

Recommended use

Fire protection of metal structures of industrial and commercial construction objects, welfare buildings and equipment exposed to the moderately cold and cold weather, I and II atmosphere types, location categories 3 and 4 according to GOST 15150-69 at relative air humidity not exceeding 85 %.

The coat is not water-resistant.

Acrylic enamel and other types of enamels may be used as the finishing coat (as agreed upon with the manufacturer). Use of other paint products in the protective coating systems is allowed only if approved by the VMP Holding.

Fire rating of the coat with metal thickness of 3.4 mm is:

• 45 minutes – coat thickness of 0.75 mm;

• 60 minutes- coat thickness of 1.2 mm

Fire rating of the coat with metal thickness of 5.8 mm is 90 minutes with coat thickness of 1.50 mm.  

Certification

Technical data

Coat

Paint

Specified state of the surface

Primer coating shall be cleaned from dirt, dust and decreased, shall be free from moisture and shall not have any corrosive degradation, flaking off and cracking.

Application

• prior to use mix thoroughly until homogeneous;
• if required prior to application dilute with water until working consistency;
  

Apply at temperatures from plus 5 to plus 40 °C and relative air humidity of up to 85 %.

The coat is not water resistant – so in the course of application one shall rule out the possibility of moistening (including condensate)!

Holding period of the primer coating prior to application of paint PLAMCOR-1 shall be not less than 24 hours.

The paint is applied in 1-4 layers depending on the fire rating requirements and metal thickness;

holding time for interlayers – not less than 12 hours at a temperature of (20±2)°C.

Natural atmospheric drying. The time of complete drying is not less than 3 days (72 hours).

The coat PLAMCOR-1 is easy to resurface.

If necessary, 1 or 2 layers (thickness 50-80 mcm) of finishing enamel may be applied onto the fire-proof coating. Holding time between application of the last layer of the fire-proof paint and application of the finishing enamel shall be not less than 24 hours.

Storage and handling

Packing: plastic buckets.

Storage and transportation of the paint are carried out in accordance with GOST 9980.5-2009 (ambient temperature from plus 5 to plus 40 °C).

During storage avoid direct sunlight and precipitation. The shelf life in air-tight original manufacturer’s containers is 12 months from the date of manufacture.

Precautions

When using paint one shall observe the respective industry-specific regulations and norms.

Compatibility with other materials

It is applied over the primer coatings TSINEP, IZOLEP-primer, IZOLEP-mastic, VINIKOR-ecoprime-01, VINIKOR-061, VINIKOR (primer-enamel) and GF-021 with a layer thickness of 40-80 microns, over other types of primers - upon agreement with the manufacturer of fire-protective paint. The enamels POLYTON-UR (UV), POLYTON-UR, VINIKOR-62, primer-enamel EVOPOL-12 and enamel PF-115 can be used as the top coating layer. Use in complex coating systems with other paints and varnishes - upon agreement with VMP representatives.

The information provided is of a general nature and does not take into account the specifics of a particular object.

   Technology of applying fire-retardant paint PLAMCOR-1.